MOTU 828x 28x30 Audio Interface with ThunderTechnology - Manual (Page 78)

C U E M I X F X
78
Monitor group assign
Click the Monitor buttons (Figure 9-6) to toggle
whether the output pair is included in the Monitor
group. See “The Monitor Group” on page 91.
THE CHANNEL SETTINGS SECTION
The channel settings section in the CueMix FX
window (Figure 9-1) displays three tabs for
Channel, EQ and Dynamics settings for the
channel with the current focus. There are also two
global tabs: the Meter Bridge and the Reverb
Processor, as shown below.
Figure 9-7: The Channel Settings section.
The Channel tab
The Channel tab (Figure 9-8) displays settings for
input channels. Click any focus button in the
Inputs tab to view the Channel tab settings for the
channel.
Figure 9-8: The Channel tab.
Signal flow
Settings in the Channel tab occur just before the
EQ, dynamics and reverb sends in the Input tab
channel strip (Figure 9-3 on page 74). Input
channel signal flow is as follows: trim, overload
protection, phase, stereo versus M/S decoding,
width, L/R swap, EQ, dynamics and reverb send.
Pad and phantom
The Pad and phantom settings become active
(ungrayed) when the focus is on a mic input (or
mic input pair). These are the same -20 dB pad and
48V phantom power settings that you can also
control from the 828x hardware itself. There are
separate settings for each mic input.
Tabs for the channel that
currently has the focus
Tabs for the global meter
bridge and reverb processor