MOTU 828x 28x30 Audio Interface with ThunderTechnology - Manual (Page 68)

R E D U C I N G M O N I T O R I N G L A T E N C Y
68
Controlling CueMix FX from within AudioDesk
or Digital Performer
To turn on CueMix FX in AudioDesk and Digital
Performer:
1 From the Setup menu, choose Configure Audio
System>Input Monitoring Mode .
2 Choose the Direct hardware playthrough option,
as shown below in Figure 8-7.
3 From the Studio menu, choose Audio Patch
Thru , and choose any monitoring mode except Off .
Figure 8-7: Enabling CueMix FX in AudioDesk or Digital Performer.
Once enabled, CueMix FX monitoring is tied with
Digital Performer or AudioDesk’s
Audio Patch
Thru feature: when you record-enable a track, the
track’s input is routed directly to its output (via
CueMix FX in the 828x hardware). For example, if
you record-enable a track called
guitar in your DP
or AudioDesk project, and its audio input
assignment is
Analog in 2 , and its audio output
assignment is optical channels 7-8, CueMix FX no-
latency hardware monitoring will automatically be
set up from analog in 2 to optical outputs 7-8.
Controlling CueMix DSP from within other
software
Consult the manual for your software.