HP DS20L - Manual (Page 84)

5-4 AlphaServer DS20L User’s Guide
5.3 Firmware Configuration Jumpers
Motherboard jumpers are used to change the configuration of the
AlphaServer DS20L system.
The factory default firmware configuration jumper block in the AlphaServer
DS20L is J2. Remove the cover to locate the jumper block. See Section 2.3.1.
Figure 5-2 shows the relative positioning of the J2 jumper with other jumpers
and connectors, and depicts all jumpers in their default position. Section 5.3.1
describes the functions of the pins.
Figure 5-2 J2 Firmware Configuration Jumper Block
MR0072A
1
2
3
5
4