HP DS20L - Manual (Page 116)

A-28 AlphaServer DS20L User’s Guide
A.8 Testing the System
The test command runs console-based exercisers for devices in the
system. Ctrl/C can abort testing.
Syntax: test [-t time] [-q] [option]
-t time Specifies the run time in seconds. The default for system test is
150 seconds (2.5 minutes).
-q Disables the display of status messages as exerciser processes
are started and stopped during testing. Sets the environment
variable d_verbose to zero.
Example A– 13 Test Command
P00>>> test
System test, runtime 150 seconds
Type ^C if you wish to abort testing once it has started
Default zone extended at the expense of memzone.
Use INIT before booting
Testing ei* devices.
No VGA/TGA available for testing
Testing Memory
Testing IDE/ATAPI disks (read-only)
ID Program Device Pass Hard/Soft Bytes Written Bytes Read
-------- ------------ ------------ ------ --------- ------------- -------------
000003cb memtest memory 1 0 0 83886080 83886080
000003ca memtest memory 1 0 0 83886080 83886080
000003cc memtest memory 1 0 0 83886080 83886080
0000042a exer_kid dqa0.0.0.16. 0 0 0 0 21504
0000042c exer_kid dqb0.0.1.16. 0 0 0 0 17408