HP DS20L - Manual (Page 147)

Index-3
Firmware configuration
jumper block, 5-5
jumper pins, 5-6
jumpers, 5-4
Front bezel removal, 1-11, 2-3
Front panel, 1-10
Front view, 1-10
H
Halt button, 1-12, 5-3
halt command, SRM, A-4, A-34
Halting the system, 5-3
Hard drive
inserting, 2-13
installing or removing, 2-9
Hard drive assembly, 2-12
Hard drives, 1-3
help command, LFU, 3-25, 3-26
help command, SRM, A-4, A-44
I
I/O
card, 1-2
shield, 1-8
slots, 1-2
specifications, 1-8
initialize command, SRM, A-4, A-23, A-
43
Initializing the system, A-43
Inserting a CD, 1-11
Inserting a hard drive, 2-13
Installation
system, 2-1
Installing
Linux, 3-18
Tru64 UNIX, 3-16
Installing a CD-ROM drive, 2-14
Installing a hard drive, 2-9
Installing a SCSI backplane, 2-10
Installing memory, 2-6
Installing options, 2-3
Installing PCI options, 2-8
Internal view, 1-14
IPK, 3-16
J
Jumper pins, 5-6
Jumpers
firmware configuration, 5-4
K
kbd_hardware_type environment
variable, SRM, A-37, A-38
L
language environment variable, SRM, A-
37, A-38
LEDs, 3-1
error statuses, 5-1
front system status, 5-1
network connector status, 5-2, 5-3
rear system status, 5-2
LFU, 3-21
commands, 3-25
from CD-ROM, 3-22
from SRM console, 3-21
starting, 3-21, 3-22
typical update procedure, 3-22
updating firmware from network
device, 3-23
lfu command, LFU, 3-25, 3-26
lfu command, SRM, 3-22, A-4, A-35
LFU commands
display, 3-25
exit, 3-22, 3-25
help, 3-25, 3-26
lfu, 3-25, 3-26
list, 3-22, 3-25, 3-26
readme, 3-25, 3-26
summary, 3-25
update, 3-22, 3-25, 3-27
verify, 3-25, 3-27
Linux
booting, 3-18