4 installing and booting linux – HP DS20L User Manual
Page 62
3-18 AlphaServer DS20L User’s Guide
3.2.4
Installing and Booting Linux
Obtain the Linux installation document and install Linux on the
system. Then verify the firmware version, boot device, and boot
parameters, and issue the boot command.
You need V5.6-3 or higher of the SRM console to install Linux. If you have a
lower version of the firmware, you will need to upgrade. For instructions and
the latest firmware images, see the following URL.
The procedure for installing Linux on an Alpha system is described in the Alpha
Linux installation document for your Linux distribution. The installation
document can be downloaded from the following Web site:
Linux Boot Procedure
1. Power up the system to the SRM console and enter the show version
command to verify the firmware version.
P00>> show version
version
V5.6-3 Mar 12 2001 08:36:11
P00>>
2. Enter
the
show device command to determine the unit number of the
drive for your boot device, in this case dkb0.0.0.5.0.
P00>>> show device
dkb0.0.0.5.0 DKB0 COMPAQ BF01865222 B004
dqb0.0.1.16.0 DQB0 SAMSUNG CD-ROM SN-124 q008
eia0.0.0.3.1 EIA0 00-02-56-00-08-7A
eib0.0.0.4.0 EIB0 00-02-56-00-08-79
pka0.7.0.3.0 PKA0 SCSI Bus ID 7
pkb0.7.0.5.0 PKB0 SCSI Bus ID 7
P00>>>