HP Vectra VE 5/series 2 - Manual (Page 73)

4 Switch the computer OFF and then ON to initialize the system ROM.
If an Error is detected by the Power-On-Self-Test
If an error is detected when the PC starts, the Error Message Utility (EMU) is launched.
• Follow the instructions provided by the EMU.
• If prompted by the EMU, press [F2] to run Setup and correct the error (refer to "Using the
HP Setup Program" in this chapter for information on using Setup).
• Press [F1] to continue and ignore the error. (It is recommended that you fix the error
before proceeding, even if the PC appears to start successfully.)
Corrective actions for errors that may prevent your PC from starting are described in the
following table.
Power-On-Self-Test Errors that May Prevent Your PC From Starting:
0130,
0241
0280 What you should do:
1 Ensure the configuration stored in CMOS memory has not been cleared by the
system board switch (refer to chapter 5).
2 Run Setup to correct the configuration information.
3 If all the above fail to correct the problem, the system board may need to be replaced.
Contact your service representative.
0250 What you should do:
1 Run Setup and correct the errors highlighted by the Setup program.
2 Ensure the configuration stored in CMOS memory has not been cleared by the
system board switch (refer to chapter 5). Make a written note of the configuration.
3 If the hardware was changed, run Setup to update the configuration information.
06xx What you should do:
1 Ensure that nothing is pushing down on the keyboard, and that no key is stuck down.
2 If the problem persists, contact your service representative.
61xx,
6500,
6510,
6520
8x06 What you should do:
1 Ensure the memory modules are installed correctly (refer to chapter 3).
2 If this does not fix the problem, initialize the system ROM (refer to “If You Can’t Start
the Setup Program” in this chapter on page 103).
3 If the problem persists, the system board may need to be replaced. Contact your
service representative.
65xx,
66xx What you should do:
1 Disable all shadowing with the Setup program.
2 If this fails to correct the problem, the system board may need to be replaced. Contact
your service representative.
8060 What you should do:
1 Check that the hard disk drive has not been disabled with the Setup program.
2 Check that the disk power and data cables are correctly connected (refer to chapter
3).
910B Explanation:
1 You connected the flexible disk drive connector B to the disk drive, and there is no
connection to a drive A.
2 Change the flexible disk drive connector to A (refer to chapter 3).