HP Vectra VE 5/series 2 - Manual (Page 103)

SYSTEM BOARD SWITCHES
System Board
Switches
Switch Use Switch Block to:
1 - CONFG Retain or clear the configuration stored in EEPROM:
• OFF to retain configuration — DEFAULT
• ON to clear configuration.
2 - PSWRD Enable or clear (and disable) User and System
Administrator Passwords stored in EEPROM:
• OFF to enable passwords — DEFAULT
• ON to clear passwords.
3 - SECURE Disable or enable security mode—security mode prevents
changes to the PC’s configuration with the Setup program:
• OFF to disable security mode — DEFAULT
• ON to enable security mode.
Switch 4 Switch 5 Switch 6 Switch 7 Switch 8
Bus
Speed Processor
Speed
ON OFF ON OFF OFF 60 MHz 150 MHz
OFF OFF ON OFF OFF 66 MHz 166 MHz
ON OFF OFF ON OFF 60 MHz 180 MHz
OFF OFF OFF ON OFF 66 MHz 200 MHz
CAUTION: These switch settings should not be changed,
unless the processor is replaced by a faster (or
slower) processor. Refer to the manual supplied
with the replacement processor to verify which
bus and processor speeds are supported.