HP Vectra VE 5/series 2 - Manual (Page 47)

1 Check that all internal cables are safely routed.
2 Slide the power supply back into the computer.
3 Tighten the two self-retaining screws.
INSTALLING MEMORY
MAIN MEMORY MODULES
Your PC is supplied with main memory. If you need more main memory to run your application
software, you can install up to a total of 256 MB. Main memory upgrades are available in pairs
of 8 MB, 16 MB, or 32 MB.
Memory modules must be installed in identical pairs of the same size and same type (a pair of
ECC or a pair of non-ECC) from bank A, up to bank D. For a list of available memory modules,
refer to the beginning of this chapter.
If your PC supports ECC (error correcting code) memory, error correcting will be disabled if any
non-ECC memory is installed.
WARNING: Static electricity can damage electronic
components. Turn all equipment OFF. Don’t let
your clothes touch the accessory.
To equalize the static electricity, rest the
accessory bag on top of the power supply while
you are removing the accessory from the bag.
Handle the accessory as little as possible and
with care.
To install a pair of main memory modules:
1 Disconnect the computer’s power cord and any telecommunications cable.
2 Remove the computer’s cover (see "Removing and Replacing the Cover" earlier in this
chapter). The location of the memory modules is shown here.