Hitachi NJI-350B User Manual
Page 78
Chapter 5 Instruction Specifications
5-28
Item number
Basic instructions-22
Name
On delay timer (ON DELAY TIMER)
Ladder format
Condition code
Processing time (
µs)
Remark
R7F4
R7F3
R7F2
R7F1
R7F0
Average Maximum
DER
ERR
SD
V
C
z
z
z
z
z
Instruction format
Number of steps
1.4
Condition
Steps
OUT TD n t s
5
Bit
Word
Double word
Usable I/O
X
Y
R,
M
TD, SS,
CU, CT
WX WY
WR,
WM TC DX DY
DR,
DM
C
o
nstant
Other
n
Timer number
{ 0 to 255 (Decimal)
t
Time base
.01s, .1s, 1s
s
Set value
{
{
{
{ 1 to 65535 (Decimal)
Function
• The progress value is updated when the startup condition is on, and the coil turns on when the progress value is greater than
or equal to the set value.
• If the startup condition is turned off, the progress value is cleared and the coil turns off.
• The progress value is set in TC n and does not exceed 65535 (decimal).
• If the progress value is updated during RUN, the operation will be performed using the new progress value at that point.
• If an I/O is set for the set value, the set value can be changed during operation by changing the I/O value, since the set values
are updated during each scan.
Notes
• The .01s time base can only be used for timer numbers 0 to 63 (64 points).
• The .1 s and 1 s time bases can be used for all timer numbers (0 to 255).
• A maximum of 256 points can be used for the timers TD, SS, CU, CTU and CTD in total.
However, the same area as the counter is used. The timer numbers and counter numbers may not be overlapped.
Program example
X00000
TD10
LD
X00000
OUT
TD10 0.01S 12345
LD
TD10
OUT
R100
TD10
R100
0.01S 12345
• An example of a word I/O being used as the set value for the circuit shown above.
R7E3
X00000
TD10
0.01S WR0010
TD10
R100
WR0010=12345
LD
R7E3
[
WR0010=12345
]
LD
X00000
OUT
TD10 0.01S WR0010
LD
TD10
OUT
R100
TD n
t x s
OU
T
TD
n
t
s