Hitachi NJI-350B - Manual (Page 36)

Chapter 4 Product lineup and wiring
4-4
4.3 14-Point Basic Unit
Name and function of each part Type EH-*14***
1] POW LED
2] OK LED
3] RUN LED
10] Terminal cover
4] Serial port cover
11] Mounting hole
5] Input terminals
8] Expansion
connector cover
9] DIP SW cover
6] Output terminals
12] DIN rail installation clip
7] Power terminal
No. Item Detailed explanation Remarks
Explanation of operation Operations are performed according to the contents of the program created
by the user.
The programming unit connected to the CPU module communication port
writes and reads the user programs.
Memory is installed inside the CPU module in which the user programs and
internal output information are stored.
1] POW LED Lighting when the power is supplied.
2] OK LED Lighting at normal operation. See Chapter 12.
3] RUN LED Lighting at RUN status.
4] Serial port cover Cover for the connector for connecting
peripheral units and the RUN switch.
When the cover is opened, the RUN switch,
potentiometers (VR), and RS-232C serial port 1
(PORT 1) can be used.
The communication specification is set to port 1. See Chapters 8 and 11.
5] Input terminals Terminals for wiring the external input units.
Recommended terminals are shown in the
figure to the right.
One piece of AWG14 to AWG22 (2.1 to
0.36 mm
2 ) or two pieces of AWG16 to
AWG22 (1.3 to 0.36 mm 2 ) per terminal may
be wired.
See Chapter 10.
(Make sure that the terminals will not
disengage due to loose screws.)
(Recommended)
6] Output terminals Terminals for connecting the external load.
The wiring specification is the same as for the input terminals. See Chapter 10.
7] Power terminal Terminal for connecting the power supply.
The wiring specification is the same as for the input terminals. See Chapter 10.
8] Expansion cover Cover for the expansion connector See Chapter 10.
9] DIP SW cover Cover for the DIP switches
When the cover is opened, the DIP switches are exposed. These DIP
switches are used to set the communication speed of serial port 1 and the
modem connection. See Chapter 11.
10] Terminal cover Cover for terminals
11] Mounting hole Used when installing the PLC with screws See Chapter 10.
12] DIN rail
installation clip Used when installing the PLC on a DIN rail See Chapter 10.
STOP RUN
VR1 VR2
PORT1
6
6