HP STORAGEWORKS SSL1016 - Manual (Page 87)

Autoloader Operation
87 SSL1016 Tape Autoloader Reference Guide
Changing the Orientation
Any magazine can be configured to fit in the right or left magazine bay.
To change the orientation of a magazine:
1. Remove the two screws that attach the handle to the front of the magazine.
Figure 59: Removing the screws
2. Unsnap the handle carefully, ensuring you do not break the hinge.
3. Rotate the handle 180 degrees so that what was the top of the handle is now
the bottom.
4. Rotate the magazine 180 degrees so that what was the front of the magazine is
now the rear.