Change the scsi id – HP STORAGEWORKS SSL1016 User Manual

Page 107

Autoloader Operation

107

Change the SCSI ID

If you need to change the autoloader’s SCSI ID, you can do so from the Web
Administration tool.

To change the SCSI ID:

1. On any Web Administration page, click Configurations.

2. From the drop-down list under SCSI ID, click the number to which you want

to set the ID.

Figure 81: Setting the SCSI ID

3. Click submit.

You must reboot the autoloader before the new SCSI ID takes effect.

Note:

For the Ultrium 460 autoloader you must set two SCSI IDs; one for the

autoloader and one for the tape drive. The default SCSI ID for the autoloader is 4. The

default SCSI ID for the tape drive is 5.