Removing the autoloader from the rack, Standalone installation, Preparation – HP STORAGEWORKS SSL1016 User Manual
Page 34
Installation and Configuration
34
SSL1016 Tape Autoloader Reference Guide
Removing the Autoloader From the Rack
When removing the autoloader from the rack:
■
Always use at least two people.
■
Install the optional installation brackets if there is no device installed below
the autoloader.
■
Before powering off the autoloader, remove the magazines.
Standalone Installation
Use these instructions if you will not be installing your autoloader into a rack.
Preparation
To prepare your autoloader for standalone installation:
1. Place one rear standalone leg into place and secure with two screws. Repeat
for the other side.
Figure 14: Installing the rear standalone leg