HP STORAGEWORKS SSL1016 - Manual (Page 131)

Troubleshooting
131 SSL1016 Tape Autoloader Reference Guide
.
Table 14: Error Messages
Error Message Description Suggested Repair
00 - 25 General software
flags
■
Power cycle the autoloader and run the Health test.
■
Check HP website for firmware updates.
26 Message Send ID
error
■
Check SCSI Bus cables and terminators.
■
Make sure the host bus adapter is installed,
detected, and configured properly.
■
Power cycle autoloader. Repeat checks after power
cycle.
27 Message bad
■
Check SCSI bus cables and terminators.
■
Make sure the host bus adapter is installed,
detected, and configured properly.
■
Power cycle autoloader. Repeat checks after power
cycle.
28 Message parameter
bad
■
Check host device driver.
■
Make sure the software application is supported,
has the autoloader correctly configured, and has
the latest patches installed.
■
Check SCSI bus cables and terminators.
■
Make sure the host bus adapter is installed,
detected, and configured properly.
■
Power cycle autoloader. Repeat checks after power
cycle.
29 Invalid element
■
Check host device driver.
■
Make sure the software application is supported,
has the autoloader correctly configured, and has
the latest patches installed.
■
Power cycle autoloader. Repeat checks after power
cycle.