HP 3200m - Manual (Page 99)

EN Advanced receive fax features and settings
97
Setting error correction
Normally, the product monitors the signals on the telephone line while
it is sending or receiving a fax. If the product detects an error signal
during the transmission and the Error Correction setting is on, the
product can request that a portion of the fax be resent.
The factory default for this setting is On. Only change it to Off if you
are having trouble sending or receiving a fax and want to accept the
errors in the transmission. Turning the setting off might be useful
when you are trying to send or receive a fax overseas or using a
satellite telephone connection.
To set error correction
1
Press E NTER /M ENU .
2
Use the < or > key to select FAX SETUP and then press E NTER /
M ENU .
3
Use the < or > key to select ALL FAXES and then press E NTER /
M ENU .
4
Use the < or > key to select ERROR CORRECTION and then press
E NTER /M ENU .
5
Use the < or > key to select ON or OFF and then press E NTER /
M ENU to save your selection.