HP 3200m - Manual (Page 180)

178
Chapter 8 - Problem Solving and Product Maintenance EN
Problem Cause Solution
The product is
feeding
multiple sheets
or jams
frequently from
the document
feeder tray.
The special media lever might be in the
incorrect position.
Guides are not adjusted properly.
The document feeder tray is too full.
The item was too thick, too slick, or
otherwise did not meet the recommended
specifications.
The special media lever should be to the
left if you are sending regular-weight
media. The lever should be to the right if
you are sending thick media, which can
only be loaded one page at a time.
Remove the document from the document
feeder tray. Straighten the item, then
reinsert it. Slide the guides against the
sides of the items to center it. Make sure
the guides are not adjusted too loosely.
Remove some of the sheets. The
document feeder tray can hold up to 30
pages, depending on the thickness of the
pages.
See “Selecting print media” on page 23.
Items loaded in
the document
feeder tray fall
forward out of
the tray.
The items are on very lightweight media. Do not try to pull the page out, because
you can damage the scanner. To remove
the page, see “Clearing jams from the
scanner path areas” on page 177. Then,
curl or roll the item in the direction of the
printed side, unroll it, and reload the item.