HP 3200m - Manual (Page 98)

96
Chapter 4 - Faxing EN
Enabling stamp received faxes
The product is set up to print the sender’s identification at the top of
each received fax. You can also choose to have your header
information included to confirm the date and time the fax was
received.
If you want the product to include your header information to each
received fax, follow the procedure below. The default setting is Off.
Note
This option only applies to received faxes that are printed by the
product.
To enable stamp received faxes
1
Press E NTER /M ENU .
2
Use the < or > key to select FAX SETUP and then press E NTER /
M ENU .
3
Use the < or > key to select FAX RECEIVE SETU P and then press
E NTER /M ENU .
4
Use the < or > key to select STAMP RECEIVED FAXES , and then
press E NTER /M ENU .
5
Use the < or > key to select ON or OFF and then press E NTER /
M ENU to save your selection.