HP 3200m - Manual (Page 42)

40
Chapter 3 - Managing General Default Settings, Logs, and Reports EN
To change the alarm volume
The alarm is heard when the device is presenting an alert or critical
error message. The alarm duration length is either one or three
seconds, based on the type of error.
Note
The default set at the factory for the alarm volume is Soft.
1
Press E NTER /M ENU .
2
Use the < or > key to select COMMON SETTINGS , and then press
E NTER /M ENU .
3
Use the < or > key to select VOLUME SETTINGS , and then press
E NTER /M ENU .
4
Press E NTER /M ENU to select ALARM VOLUME .
5
Use the < or > key to select OFF , SOFT , MEDIUM , or LOUD , and
then press E NTER /M ENU to save your selection.
To change control panel key press volume
The key press volume will be heard when a control panel key is
pressed.
Note
The default set at the factory for the control panel key press is Soft.
1
Press E NTER /M ENU .
2
Use the < or > key to select COMMON SETTINGS , and then press
E NTER /M ENU .
3
Use the < or > key to select VOLUME SETTINGS , and then press
E NTER /M ENU .
4
Use the < or > key to select KEY PRESS VOLUME , and then press
E NTER /M ENU .
5
Use the < or > key to select OFF , SOFT , MEDIUM , or LOUD , and
then press E NTER /M ENU to save your selection.