Epson 4003353 - Manual (Page 64)

Stylus Service Manual Disassembly and Assembly
3.1 OVERVIEW
This section describes the procedures for disassembling the main components of this printer.
Unless otherwise specified, the disassembled unit or components can be reassembled by reversing
the disassembly procedure. Therefore no assembly procedures are included. Precautions for any
disassembly or assembly procedure are described under the heading “Disassembly/Assembly
Points.” Adjustments required after assembling the unit are described under the heading “Required
Adjustments.”
3.1.1 Precautions for Disassembling the Printer
See the precautions below when disassembling the printer.
Disconnect the power before disassembling or assembling the printer.
to protect your ink. in your eye, flush your eye
water and see a doctor immediately.
ink comes into contact with your skin, wash it with soap and water.
occurs, contact a physician.
■ A lithium battery is installed on the board of this printer. Be sure to
the instructions when servicing the battery:
2.
3.
4.
5.
6.
Keep the battery away from any metal or other batteries so that electrodes of opposite
polarity do not come in contact with each other.
Do not heat the battery or put it near fire.
Do not solder on any part of the (Doing so may result in leakage of electrolyte
from the burning, or explosion. The leakage may other devices close to the
Do not change the battery. (An explosive gas may be generated inside the battery, and
cause burning or explosion.)
Do not dismantle the battery. (The gas inside the
may hurt your throat. Leakage,
burning, or explosion may also result.)
Do not install the
in the wrong direction. (This may cause or
■ Never remove the ink the carriage unless specified to do so.
When transporting installing the ink cartridge, be sure to pack the printer
for transportation without removing the ink cartridge.
Use only recommended tools assembling,
Apply lubricants and adhesives as (See Chapter 6.)
Make adjustments when you disassemble the printer. (See Chapter 4.)
There is a danger of explosion if the is correctly. Replace only the
same or equivalent type recommended by the Dispose of used batteries
according to laws and regulations.
Rev. 3-1