1 preventive maintenance – Epson 4003353 User Manual

Page 114

Stylus

Service

6.1 PREVENTIVE MAINTENANCE

Although this printer is designed so that no specific maintenance is required on a regular basis, it is
recommended that you clean the printer thoroughly whenever you get a chance to do so. You can
clean:

Outer case

Use a soft, clean cloth, dampened with mild detergent, if necessary.

Auto sheet feeder

If the inside of the auto sheet feeder is dirty (dusty), carefully brush away all dust and dirt

using a soft brush. If the pickup roller of the sheet feeder is dirty, clean its surface with a soft,
clean cloth.

Inside the printer

If you notice any dust or dirt that has accumulated inside the printer when you open the outer
case for repair, remove all dust and dirt using a small vacuum cleaner designed for such
purposes.

Never use paint thinner,

or ketone-based solvents for cleaning. These

chemicals can damage the components of the printer.

■

Do not use a hard or abrasive brush

not to damage the components of

vacuum cleaner.

A lithium

is installed on the

sure to observe

the

instructions when servicing the

the after-service parts:

Keep the

any metal or other batteries so

of opposite

polarity do not come in contact

each other.

2. Do not heat the

and place it near

3. Do not solder on any part of the

(Doing so may result in leakage of electrolyte

from the battery,

explosion. The leakage may damage devices close to the

battery.)

4. Do not change the

may be generated

the battery, and

cause burning or explosion.)

5. Do not dismantle the

(The gas inside the battery may hurt your throat. Leakage,

burning, or explosion may also result.)

6. Do not install the battery in the wrong direction. (This may cause burning or explosion.)

Rev. A