Audio – Crestron electronic 7" Room Scheduling Touchscreen with Light Bar for Rooms (Black Smooth) User Manual
Page 122

118 • TSS-70 Series
Product Manual — Doc. 8745H
l
Device Model: Use the drop-down menu to select POE Occ Sensor.
l
Pairing Retry Time (Min): Enter a duration (in minutes) that must elapse before the CEN-ODT-C-
POE reattempts to pair to the touch screen.
l
Pairing Status: Reports whether the CEN-ODT-C-POE is paired to the touch screen (Online) or
not (Offline).
Device IP Address/FQDN: Enter the IP address or fully qualified domain name of the CEN-ODT-C-
POE. This is required for device pairing.
Device Authentication: Enter authentication credentials for the CEN-ODT-C-POE (if required):
o
Device Username: Enter a valid username used to access the device.
o
Device Password: Enter a valid password used to access the device.
Audio
Select Audio to configure various audio settings for the touch screen.
Settings Tab – Audio
NOTE: The Media Volume setting adjusts the H.264 streaming media level in relation to the Panel
Volume setting.
l
Panel Mute: Turn on the toggle to mute the main touch screen volume.
l
Panel Volume: Enter a value (1‒100) for the main touch screen volume level.
l
Media Mute: Turn on the toggle to mute the touch screen media volume.
l
Media Volume: Enter a value (1‒100) for the touch screen media volume level.
l
Beep Enabled: Turn on the toggle to mute the touch screen beep volume.
l
Beep Volume: Enter a value (1‒100) for the touch screen beep volume.