ARRI ALEXA 35 Body & PL Mount Set (LBUS) - Manual (Page 86)

Network 86
20 Network
A network connection can be used to remotely control the camera. The camera's Web Remote, the
Camera Companion App or other applications communicating with the camera via the Camera Access
Protocol (CAP) can be connected to the camera via Ethernet or WiFi.
The Ethernet connector (1) is located on the right side of the camera.
Use the ALEXA ETH/RJ45 (3.0m/9.8ft) KC 153-S (K2.72021.0) cable
to connect the camera to a computer or network.
The camera is equipped with a 2.4 GHz WiFi module and two WiFi
antennas (2, 3), both located on the back of the camera.
The WiFi module of the camera can be configured to act as an ac-
cess point or in infrastructure (client) mode.
ADVICE
Electrostatic Discharge on Open Connector.
The WiFi module might be damaged by electrostatic discharge when leaving the connector
without antenna attached.
Do not leave the antenna connectors open during operation or transport.
Use only the type of antenna originally supplied.
20.1 WiFi Settings
WiFi Power
► Select MENU > System > Network / WiFi > WiFi Power or
► Select Side Display > Settings > WiFi
to enable/disable WiFi.
WiFi Mode
► Select MENU > System > Network / WiFi > WiFi Mode .
The WiFi mode can only be changed while WiFi power is disabled.
Following options are available:
Host The camera acts as an WiFi access point. The SSID of the camera is ALEXA35-xxxxx.
(xxxxx is the five digit serial number of the camera)
Client The camera can connect to a WiFi network and receives it's IP address via DHCP.