ARRI ALEXA 35 Body & PL Mount Set (LBUS) User Manual
Page 35
Status Information and Overlays
35
Show Numeric Values
Sub-option of Electronic Horizon. Shows the tilt and roll of the camera in degrees as
measured by the camera's position sensor.
Lens Data
Lens Focus Distance
Depth of Field
Distance Measure
Enables/disables iris (3) and focal length (7) overlays.
Enables/disables focus distance overlay (21).
Enables/disables the depth of field overlays (23, 24).
Enables/disables status overlay of distance readings from a distance measure connected
to the SERIAL connector (22).
Master Grips / OCU-1 Control
Info Left
Info Right
Info Top
Info Bottom
Audio
Timecode
Enables/disables status overlay of Master Grips / OCU-1 axis control (20).
Enables/disables the left section of the status info.
Enables/disables the right section of the status info.
Enables/disables the top section of the status info.
Enables/disables the bottom section of the status info.
Enables/disables display of the audio levels (16).
Enables/disables display of the timecode (12).
Overlay Brightness
The camera allows adjusting the brightness of the status overlays.
► Select
MENU > Monitoring > VF > EVF Overlays > Overlay Brightness
to adjust the overlay
brightness for the EVF.
► Select
MENU > Monitoring > SDI > SDI 1 Processing > Overlays > Overlay Brightness
to adjust the
overlay brightness for the SDI 1 output.
► Select
MENU > Monitoring > SDI > SDI 2 Processing > Overlays > Overlay Brightness
to adjust the
overlay brightness for the SDI 2 output.
► Set the overlay brightness in a range from
1
(the lowest brightness) to
4
(the highest brightness).
Flip-out Monitor Status Bar
The flip-out monitor of the MVF-2 shows a slightly different status information than the EVF and the SDI
outputs. When set to display the camera live image, a status bar is displayed below the image. The flip-
out monitor status bar is separated into five pages:
Lens Data
Recording
Main Parameters
Audio and Timecode
Status Icons
1
2
► Use the left and right lower screen buttons to
change the status bar (1) content. The center lower
screen button (2) returns to display the main para-
meters.