ARRI ALEXA 35 Body & PL Mount Set (LBUS) User Manual
Page 67
Monitoring
67
► Select
MENU > Monitoring > SDI > SDI 2 Processing > Overlays > Frame Lines
to toggle display of
frame lines and center mark on the SDI 2 output.
User Buttons
VF Frame Lines, SDI 1 Frame Lines, SDI 2 Frame Lines
support to quickly
enable/disable display of frame lines for the corresponding output.
Frame Line Display
When creating custom frame lines using the ARRI Frame Line & Lens Illumination Tool, you have
the possibility to place up to three different frame lines (A, B, C) in one frame line file. However, the
camera does not always have to display all three frame lines at the same time, but offers the possibility
to configure which frame line(s) are displayed. This allows you to quickly switch between or combine
these frame lines without having to load a new frame line file each time.
► Select
MENU > Monitoring > Frame Lines > Frame Line Display
Following options are available:
Frame Line A
Frame Line B
Frame Line C
Toggle to enable/disable display of frame line A of the set frame line file.
Toggle to enable/disable display of frame line B of the set frame line file.
Toggle to enable/disable display of frame line C of the set frame line file.
Frame Line Color
The Frame Line Color setting defines the color of the frame line(s), the Center Mark, the User
Rectangle(s) and the Surround Mask (if Surround Mask is set to
Colored Line
).
► Select
MENU > Monitoring > Frame Lines > Frame Line Color
.
Following options are available:
Red
Green
Blue
Cyan
Magenta
Yellow
Black
White
Frame Line Opacity
The Frame Line Opacity setting defines the opacity of the frame line(s), the center mark, the user
rectangle(s) and the surround mask (if surround mask is set to
Colored Line
).
► Select
MENU > Monitoring > Frame Lines > Frame Line Opacity
► Set the frame line opacity in a range from
1
(the lowest opacity) to
4
(the highest opacity).
Outside Shading
The Outside Shading setting applies shading to the area between the frame line(s) and the remaining
captured image area and can be set independently for each image output. When changing the Outside
Shading of an output, the output's Surround Mask is adapted accordingly.
► Select
MENU > Monitoring > Frame Lines > Outside Shading
.
Following options are available:
EVF Outside Shading
Monitor Outside Shading
SDI 1 Outside Shading
SDI 2 Outside Shading
Set the outside shading for the EVF (Off, 25%, 50%, 75%, 100%).
Set the outside shading for the Monitor (Off, 50%, 100%).
Set the outside shading for the SDI 1 output (Off, 25%, 50%, 75%, 100%).
Set the outside shading for the SDI 2 output (Off, 25%, 50%, 75%, 100%).
User Rectangles
To further aid in framing, the camera supports to display two custom user rectangle overlays.