ProSoft Technology MVI69-101S - Manual (Page 42)

MVI69-101S ♦ CompactLogix or MicroLogix Platform Configuring the MVI69-101S Module
IEC 60870-5-101 Slave Communication Module
Page 42 of 149 ProSoft Technology, Inc.
March 16, 2009
Monitor Point #
Monitor
DB addr
Each point is one byte and the DB address value corresponds to the byte offset
in the database.
The database address should be located in a database area that is being
constantly moved from the MVI69-101S to the CompactLogix or MicroLogix
processor. You should configure the DB address parameter in an area that is on
a Backplane Command Function 2.
2.15 [C_SE_NA_1]
This section defines the normalized setpoint database for the slave emulated.
This information is sourced from the remote master and is transferred to the
database. Each point occupies a word position in the database. If the Require
Select parameter is not set to zero, a select command must be received before
an execute command will be processed.
This section takes the following parameters:
Point #
DB address
Monitor Point #
Monitor
DB addr
Require Select
Each point is one word and the DB address value corresponds to the word offset
in the database.
The database address should be located in a database area that is being
constantly moved from the MVI69-101S to the CompactLogix or MicroLogix
processor. You should configure the DB address parameter in an area that is on
a Backplane Command Function 2.
2.16 [C_SE_NB_1]
This section defines the scaled setpoint database for the slave emulated. This
information is sourced from the remote master and is transferred to the database.
If the Require Select parameter is not set to zero, a select command must be
received before an execute command will be processed.
This section takes the following parameters:
Point #
DB address
Monitor Point #
Monitor
DB addr
Require Select
Each point is one word and the DB address value corresponds to the word offset
in the database.