PLANET WGSW-28040P - Manual (Page 219)

User’s Manual of WGSW-28040 / 28040P / 28040P4
219
1. For security reason, please change and memorize the new password after this first setup.
2. Only accept command in lowercase letter under console interface.
Configure IP address
The SGSW Managed Switch is shipped with default IP address as following.
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please use the procedures as follow:
 Show the current IP address
1. On ”WGSW-28040#” prompt, enter “config”.
2. On ”WGSW-28040(config)#” prompt, enter “show ip”.
3. The screen displays the current IP address, Subnet Mask and Gateway. As show in Figure 5-2 .
Figure 5-2 Show IP information screen
 Configure IP address
4. On “WGSW-28040(config)#” prompt, enter the following command and press . As show in Figure 5-3 .
WGSW-28040(config)# ip address 192.168.1.100 255.255.255.0
WGSW-28040(config)# ip default-gateway 192.168.1.254
The previous command would apply the follow settings for the Switch.