PLANET WGSW-28040P - Manual (Page 138)

User’s Manual of WGSW-28040 / 28040P / 28040P4
138
The states a computer will go through to join or to leave a multicast group are shown below:
Figure 4-7-4 IGMP State Transitions
 IGMP Querier –
A router, or multicast-enabled switch, can periodically ask their hosts if they want to receive multicast traffic. If there is more
than one router/switch on the LAN performing IP multicasting, one of these devices is elected “querier” and assumes the
role of querying the LAN for group members. It then propagates the service requests on to any upstream multicast
switch/router to ensure that it will continue to receive the multicast service.
Multicast routers use this information, along with a multicast routing protocol such as
DVMRP or PIM, to support IP multicasting across the Internet.
This section has the following items:
 IGMP Snooping Setting Configures IGMP snooping settings
 IGMP VLAN Setting Configuration per VLAN LGMP snooping settings
 Multicast Database Display current multicast database
 Router Table Display current router table