beautypg.com

Chapter 2: hardware and software setup, Chapter, Describes ho – Avago Technologies Syncro CS 9286-8e User Manual

Page 9

background image

Avago Technologies

- 9 -

Syncro CS 9286-8e Solution User Guide
November 2014

Chapter 2: Hardware and Software Setup

Chapter 2: Hardware and Software Setup

This chapter describes how to set up the hardware and software for a Syncro CS 9286-8e

solution with two controller

nodes and shared storage. For this implementation, you use two standard server modules with Syncro CS 9286-8e
controllers that provide access to disks in one or more JBOD enclosures for reliable, high-access redundancy.

The LSI Syncro CS 9286-8e controller kit includes the following items:

Two Syncro CS 9286-8e controllers

Two CacheVault Flash Modules 03 (CVFM03) (pre-installed on the controllers)

Two CacheVault Power Modules 02 (CVPM02)

Two CVPM02 mounting clips and hardware

Two CVPM02 extension cables

Two low-profile brackets

Syncro CS 9286-8e Controller Quick Installation Guide

Syncro CS Resource CD

The hardware configuration for the Syncro CS 9286-8e solution requires the following additional hardware that is not

included in the kit:

Two server modules from the approved compatibility list from LSI. The servers must include network cards.

One or more JBOD enclosures with SAS disk drives from the approved compatibility list from LSI.

A monitor and a pointing device for each server node.

Network cabling and SAS cabling to connect the servers and JBOD enclosures.

The following figure shows a high-level diagram of a Syncro CS 9286-8e solution connected to a network.