Avago Technologies Syncro CS 9286-8e - Manual (Page 17)

Avago Technologies
- 17 -
Syncro CS 9286-8e Solution User Guide
November 2014 Chapter 2: Hardware and Software Setup
Cabling Configurations
Figure 7 Adding a Second JBOD Enclosure – Redundant Configuration
The steps for adding the second JBOD enclosure are as follows:
1. Connect a link from connector 2 on Expander B of JBOD enclosure A to connector 1 on expander B of JBOD
enclosure B.
2. Disconnect the link from connector 1 on expander A of JBOD enclosure A and reconnect it to connector 1 on
expander A of JBOD enclosure B.
3. Disconnect the link from connector 0 on expander A of JBOD enclosure A and reconnect it to connector 0 on
expander A of JBOD enclosure B.
4. Connect the link from connector 2 on expander A of JBOD enclosure B to connector 0 on expander A of JBOD
enclosure A.
?
6HUYHU1RGH$
6\QFUR&6H
6HUYHU1RGH%
6\QFUR&6H
'ULYH(QFORVXUH$
([SDQGHU$
#ONNECTOR #ONNECTOR
#ONNECTOR
([SDQGHU%
#ONNECTOR #ONNECTOR
#ONNECTOR
'ULYH(QFORVXUH%
([SDQGHU$
#ONNECTOR
([SDQGHU%
#ONNECTOR
4OP
#ONNECTOR
"OTTOM
#ONNECTOR
#ONNECTOR #ONNECTOR #ONNECTOR #ONNECTOR
4OP
#ONNECTOR
"OTTOM
#ONNECTOR