Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 53)

Controller Object Commands
www.lsi.com/channel/products 45
/cx show phy
The /cx show phy command shows a list of the phys with related information
for the specified controller.
In the following example, the column Device Type indicates whether the
connected device is an enclosure, or a SATA or SAS drive. The Device
column is the device ID or handle. There are three Link Speed columns:
Supported denotes the link speed capability of the phy/device, Enable denotes
the current link speed setting, and Control denotes the link control setting.
Example of 9690SA-8E connected to drives in an enclosure:
// localhost> /c3 show phy
Device --- Link Speed (Gbps) ---
Phy SAS Address Type Device Supported Enabled Control
--------------------------------------------------------------------------
phy0 500050e000030232 ENCL N/A 1.5-3.0 3.0 Auto
phy1 500050e000030232 ENCL N/A 1.5-3.0 3.0 Auto
phy2 500050e000030232 ENCL N/A 1.5-3.0 3.0 Auto
phy3 500050e000030232 ENCL N/A 1.5-3.0 3.0 Auto
phy4 500050e000030236 ENCL N/A 1.5-3.0 3.0 Auto
phy5 500050e000030236 ENCL N/A 1.5-3.0 3.0 Auto
phy6 500050e000030236 ENCL N/A 1.5-3.0 3.0 Auto
phy7 500050e000030236 ENCL N/A 1.5-3.0 3.0 Auto
In the previous example, for phy1, the link speeds supported are 1.5 Gb/s and
3.0 Gb/s. The current link speed for phy1 is 3.0 Gbps, and the link control
setting is Auto. The link control setting could be either 1.5, 3.0, or Auto. Auto
denotes Automatic Negotiation, where the best negotiated speed possible for
that link is used.
(Note that if SAS 2.0 is used with a 9750 controller, the link speeds can be up
to 6.0 Gb/s.)
Example of 9690SA-8I with direct attached drives:
//localhost> /c3 show phy
Device --- Link Speed (Gbps) ---
Phy SAS Address Type Device Supported Enabled Limit
--------------------------------------------------------------------------
phy0 500050e000000002 SATA /c3/p0 1.5-3.0 3.0 Auto
phy1 500050e000000002 SATA /c3/p1 1.5-3.0 3.0 Auto
phy2 500050e000000002 SATA /c3/p2 1.5-3.0 3.0 Auto
phy3 500050e000000002 SATA /c3/p3 1.5-3.0 3.0 Auto
phy4 - - - 1.5-3.0 - Auto
phy5 - - - 1.5-3.0 - Auto
phy6 500050e000000006 SAS /c3/p6 1.5-3.0 3.0 Auto
phy7 - - - 1.5-3.0 - Auto