Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 33)

Shell Object Commands
www.lsi.com/channel/products 25
Help Commands. Help commands allow you to get help information for all
commands and attributes. For details, see “Help Commands” on page 122.
Shell Object Commands
Shell object commands either apply to all the controllers in the system (such
as show, rescan, flush, commit), or they redirect the focused object.
Syntax
focus object
commit
flush
rescan
show [attribute [modifier]]
alarms [reverse]
diag
rebuild
selftest
ver
verify
update fw=filename_with_path [force]
focus Object
The focus command is active in interactive mode only and is provided to
reduce typing.
The focus command sets the specified object in focus and changes the prompt
to reflect the specified object. This allows you to type a command that applies
to the specified object instead of typing the entire object name each time.
For example, where normally you might type:
/c0/u0 show
If you set the focus to /c0/u0 , the prompt changes to reflect /c0/u0 , and you
only have to type show . The concept is similar to working in a particular
location in a file system and requesting a listing of the current directory.
When you type the command focus /object, object can have the following
forms:
• /cx/ux specifies the fully qualified Universal Resource Identifier (URI)
of an object on controller cx , unit ux .
• .. (two trailing periods) specifies one level up (the parent object).
• / (a forward slash) specifies the root
• object specifies the next level of the object.