Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 29)

Common Tasks Mapped to CLI Commands
www.lsi.com/channel/products 21
Set the storsave profile /cx/ux set storsave 84
Unit Configuration Changes
Change RAID level /cx/ux migrate 86
Change stripe size /cx/ux migrate 86
Expand unit capacity /cx/ux migrate 86
Delete a unit /cx/ux del 79
Remove a unit (export) /cx/ux remove 78
Name a unit /cx/ux set name 83
Unit Maintenance Tasks
Start a rebuild /cx/ux start rebuild 79
Start a verify /cx/ux start verify 80
Stop verify /cx/ux stop verify 80
Enable/disable autoverify /cx/ux set autoverify 81
Identify all drives that make up a
unit by blinking associated LEDs /cx/ux set identify 64
Port Tasks
Locate drive by blinking an LED /cx/px set identify 101
Check if LED is set to on or off /cx/px show identify 94
View information for specific drive /cx/px show 92
View the status of specific drive /cx/px show status 95
Show statistics for the drive on a
particular port /cx/px show dpmstat
type=inst|ra|lct|histdata|ext 98
Clear statistics counters for a
particular drive /cx/px set dpmstat=clear
[type=ra|lct|ext] 101
PHY Tasks
View details about link speed for a
specified phy /cx/phyx show 102
Set the link speed for a specified
phy /cx/phyx set link=auto|1.5|3.0|6.0 103
BBU Tasks
Table 5: Common Tasks Mapped to CLI Commands (Continued)
Task CLI Command Page