Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 48)

Chapter 2. CLI Syntax Reference
40 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
/cx show monitor
The /cx show monitor command shows the monitor (firmware boot-loader)
version of controller /cx.
Example:
//localhost> /c0 show monitor
/c0 Monitor Version = BLDR 2.x
/cx show numdrives
The /cx show numdrives command shows the number of drives currently
managed by the specified controller /cx. This report does not include
(logically) removed or exported drives.
Example:
//localhost> /c0 show numdrives
/c0 Number of Drives = 5
/cx show numports
The /cx show numports command shows the total number of physical
connections made to the controller and the maximum connections possible for
the controller.
Example for a 9650SE-16ML with no drives attached:
//localhost> /c0 show numports
/c0 Number of Ports = 16
Example for 9690SA-8E with 8 dual-port SAS drives:
//localhost> /c3 show numports
/c3 Connections = 16 of 128
/cx show numunits
The /cx show numunits command shows the number of units currently
managed by the specified controller /cx. This report does not include off-line
units (or removed units).
Example:
//localhost> /c0 show numunits
/c0 Number of Units = 1
/cx show pcb
The /cx show pcb command shows the Printed Circuit Board (PCB) version
of the specified controller /cx.
Example:
//localhost> /c0 show pcb
/c0 PCB Version = RevX