Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 12)

Chapter 1. Introduction to the 3ware Command Line Interface
4 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
To install 3ware CLI on Linux, FreeBSD, OpenSolaris, or VMWare
do one of the following:
• Copy the file.
CLI binary and executable files are located on the 3ware CD in the
following directory:
/packages/cli
Navigate to the appropriate folder under /packages/cli for your OS.
Coy the file tw_cli to an appropriate location on your system where you
can easily access the file. Make sure to copy the correct version for your
OS and OS architecture (32-bit or 64-bit).
Online manual pages are also available in nroff and html formats. These
are located in
/packages/cli/tw_cli.8.html or tw_cli.8.nroff.
You must be root or have root privileges to install the CLI to
/usr/sbin and to run the CLI.
• Use the setup command from a command line.
For Linux
a Navigate to one of the following directories on the 3ware CD
/packages/installers/tools/linux
b Type
./install.sh -i
c Respond to each screen as the script walks you through the
installation.
d After the installation is complete, check that the software was
installed correctly.
For FreeBSD
a Navigate to the directory on the mounted image or CD that contains
the installer:
/packages/installers/tools/freebsd
b Type
./install.sh -i
Notes:
When copying the CLI, it is best to copy it to a location that is in the
environment path so you can run CLI without using the complete path
(i.e., /usr/sbin)
Otherwise you will have to type the complete path:
/home/user/tw_cli