Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 28)

Chapter 2. CLI Syntax Reference
20 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
Update controller with new
firmware /cx update 58
Add a time slot to a rebuild
schedule /cx add rebuild 59
Add a time slot to a verify
schedule /cx add verify 60
Add a time slot to a selftest
schedule /cx add selftest 61
Enable/disable the initialize/
rebuild/migrate schedule and set
the task rate /cx set rebuild 63
Enable/disable the verify schedule
and set the task rate /cx set verify 65
Set the verify schedule to
advanced or basic /cx set
verify=advanced|basic|1..5 66
Set the rebuild/migrate task rate /cx set rebuildrate 64
Set the rebuild/migrate task mode /cx set rebuildmode 63
Set the verify task rate /cx set verifyrate 67
Set the verify task mode /cx set verifymode 66
Set the basic verify start time and
day /cx set verify=basic [pref=ddd:hh] 66
Enable/disable the selftest
schedule /cx set selftest 68
View controller alarms (errors,
warnings, messages) /cx show alarms
/cx show events
/cx show AENs
43
Unit Configuration Tasks
View information about a unit /cx/ux show 72
Create a unit or hot spare /cx add 53
Enable/disable unit write cache /cx/ux set wrcache 81
82
Enable Basic or Intelligent read
cache, or disable both. /cx/ux set rdcache 82
Set the queue policy /cx/ux set qpolicy 84
Set the rapid RAID recovery policy /cx/ux set rapidrecovery 84
Table 5: Common Tasks Mapped to CLI Commands (Continued)
Task CLI Command Page