Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 132)

Chapter 2. CLI Syntax Reference
124 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2
bios|carvesize(9000series)|
driver|drivestatus|firmware|memory|model|
monitor|numdrives|numports|numunits|ctlbus(9000 series
SX/SE/SA only)|serial|pcb|
pchip|spinup|stagger|unitstatus|
/cx show all where all means attributes and configurations.
/cx show diag
/cx show alarms [reverse]
/cx show rebuild (9000 only)
/cx show verify (9000 only)
/cx show selftest (9000 only)
//localhost>
help
The help command provides a table of contents to help with the overall
navigation of the CLI commands.
For example:
Typical output is similar to the following example.
//localhost> help
Copyright (c) 2010 LSI
LSI/3ware CLI (version 2.00.11.010)
Commands Description
-------------------------------------------------------------------
focus Changes from one object to another. For Interactive Mode Only!
show Displays information about controller(s), unit(s) and port(s).
flush Flush write cache data to units in the system.
rescan Rescan all empty ports for new unit(s) and disk(s).
update Update controller firmware from an image file.
commit Commit dirty DCB to storage on controller(s). (Windows only)
/cx Controller specific commands.
/cx/ux Unit specific commands.
/cx/px Port specific commands.
/cx/phyx Phy specific commands.
/cx/bbu BBU specific commands. (9000 only)
/cx/ex Enclosure specific commands. (9690SA only)
/ex Enclosure specific commands. (9KSX/SE only)
Certain commands are qualified with constraints of controller type/model
support. Please consult the tw_cli documentation for explanation of the
controller-qualifiers.
Type help to get more details about a particular command.
For more detail information see tw_cli's documentation.
help focus
The help focus command provides specific focus-related help, illustrating
various ways to use the focus command. See the section “Shell Object
Commands” on page 25 for more information.