Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 119)

Enclosure Object and Element Commands
www.lsi.com/channel/products 111
pwrs0 OK on OK OK Off
pwrs1 OK on OK OK Off
Slot Status VPort Identify
--------------------------------------------------
slot0 OK /c0/p0 Off
slot1 NO-DEVICE - Off
slot2 OK /c0/p1 Off
slot3 OK /c0/p2 Off
slot4 OK /c0/p3 Off
slot5 OK /c0/p4 Off
slot6 OK /c0/p5 Off
slot7 OK /c0/p6 Off
slot8 OK /c0/p7 Off
slot9 OK /c0/p8 Off
slot10 OK /c0/p9 Off
slot11 NO-DEVICE - Off
Alarm Status State Audibility
--------------------------------------------------
alm0 OK OFF UNMUTE
/cx/ex show attribute [attribute ...]
The /cx/ex show attribute command applies to 9750 and 9690SA controllers.
For the 9650SE, simply drop the prepended controller name in the command
and use /ex.
The /cx/ex show attribute command shows the current setting of one or more
attributes. You can specify one or many attributes. If you specify an invalid
attribute, the loop terminates. Possible attributes are: controllers, slots, fans,
temp, pwrs (power supply), and alms (alarms).
/cx/ex show controllers
The /cx/ex show controllers command applies only to 9750 and 9690SA
controllers. For the 9650SE, simply drop the prepended controller name in the
command and use /ex. This command is primarily useful for 9650SE
controllers, where the enclosure number might not already be known.
The /cx/ex show controllers command lists the controller associated with
enclosure /cx/ex.
Example:
//localhost> /e0 show controllers
e0 connects to controller /c0