KEPCO KLP Series Developers Guide, Rev 3 - Manual (Page 74)

5-12
KLP-DEV 041213
The Virtual Model button opens the Virtual Model window (Figure 5-10). The Unit Password
must be entered, then the voltage and current limits for a virtual model can be set.
FIGURE 5-10. VIRTUAL MODEL WINDOW
The Front Panel button allows the front panel keyboard to be locked during remote operation.
The Utilities button opens the Utilities window (Figure 5-11).
The Calibration Data Dump button allows calibration data in hex format to be sent to the host
computer via the GPIB.
If the correct password is entered, the calibration Data Restore button allows the unit to accept
previously dumped calibration data and replace the Working calibration.
The Hardware Test button tests the validity of system parameters (e.g., CRC).
The Full Power Test button performs a full power test by first testing maximum voltage output,
then testing minimum voltage output.
FIGURE 5-11. UTILITIES WINDOW
The Reset button resets the unit to the power up defaults: output voltage set to zero, current set
to minimum current, and output off.
The QUIT button on the Main panel (Figure 5-5) is used to exit the sample VXI plug&play appli-
cation.