KEPCO KLP Series Developers Guide, Rev 3 - Manual (Page 42)

3-20
KLP-DEV 041213
3.5.2 GETTING A VOLTAGE AND CURRENT READING FROM THE POWER SUPPLY
Figure 3-7 illustrates the use of the IVI-COM driver with LabView to measure the KLP output.
FIGURE 3-7. MEASURING VOLTAGE AND CURRENT USING LABVIEW WITH IVI-COM DRIVER
3.5.3 CHANGING THE VIRTUAL MODEL
The virtual model Vi is very similar to the output setting and measurement examples; it has the
the identical open and close functionality. The middle three blocks set the password, then cause
the voltage limit and the current limit to be applied to the KLP. This is done using the Max Posi-
tive Current Limit and Max Positive Voltage Limit properties. As indicated in the earlier table
these are the setting nodes that are required to change the KLP virtual model.
FIGURE 3-8. SETTING THE VIRTUAL MODEL USING LABVIEW WITH IVI-COM DRIVER