KEPCO KLN 750W Series, Firmware Version 1.60 to 1.6x - Manual (Page 49)

KLN 750W 032614
3-13
3.3.20 SET 1ST PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set first part (nnn) of the 4-part IP address (nnn.xxx.xxx.xxx) where nnn can be set from
0 to 254. Set DHCP on/off to OFF before using this function (see PAR. 3.3.19).
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP1) to access first part of IP address.
2. Press ENTER key to view setting.
For example, (192) displayed in Current display for IP Address 192.xxx.xxx.xxx
3. Rotate encoder until Current display shows desired setting (tap encoder to adjust 10’s or
100’s digit more rapidly). Press ENTER to confirm.
3.3.21 SET 2ND PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set second part (nnn) of the 4-part IP address (xxx.nnn.xxx.xxx) where nnn can be set
from 0 to 254.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP2) to access second part of IP address.
2. Press ENTER key to view setting.
For example (168) displayed in Current display for IP Address xxx.168.xxx.xxx.
3. Rotate encoder until Current display shows desired setting (tap encoder to adjust 10’s or
100’s digit more rapidly). Press ENTER to confirm.
3.3.22 SET 3RD PART OF IP ADDRESS (LAN INTERFACE ONLY)
Used to set third part (nnn) of the 4-part IP address (xxx.xxx.nnn.xxx) where nnn can be set
from 0 to 254.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (S.IP3) to access third part of IP address.
2. Press ENTER key to view setting.
For example (0) displayed in Current display for IP Address xxx.xxx.0.xxx.
3. Rotate encoder until Current display shows desired setting (tap encoder to adjust 10’s or
100’s digit more rapidly). Press ENTER to confirm.