KEPCO KLN 750W Series, Firmware Version 1.60 to 1.6x - Manual (Page 48)

3-12
KLN 750W 032614
3.3.17 GPIB ADDRESS (GPIB INTERFACE ONLY)
Used to set the GPIB address. Available addresses from 01 to 31. Default GPIB address is 07.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (GPIB) to access GPIB ADDRESS setting.
2. Press ENTER key to view setting.
GPIB address (default) displayed as (07) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.18 RS-485 ADDRESS
Used to set the RS-485 address. Available addresses from 001 to 254. Default RS-485 address
is 007.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (485), then (GPIB) if GPIB option is installed, then
(485) to access RS-485 ADDRESS setting.
2. Press ENTER key to view setting.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.
3.3.19 DHCP FUNCTION ON/OFF CONTROL (LAN INTERFACE ONLY)
Used to allow the IP address to either be assigned from the DHCP server (on) or assigned by
the user when connecting the unit directly to a computer (off). Refer to V.IP functions (see PAR.
3.3.32 through 3.3.35) to view IP address. Refer to S.IP functions (see PAR. 3.3.20 through
3.3.23) to set static IP address.
1. Enter the menu (see PAR. 3.2.2 and Table 3-3) and rotate the encoder until Voltage display
shows (DHCP) to access DHCP on/off setting.
2. Press ENTER key to view setting.
DHCP ON displayed as (ON) in Current display.
DHCP ON displayed as (OFF) in Current display.
3. Rotate encoder until Current display shows desired setting, then press ENTER to confirm.