TA Triumph-Adler DC 2162 - Manual (Page 24)

Copying Functions
1-18
Margin Mode
You can shift the original image to make space on the copy for binding on the left (right) or top
(bottom) side. The supported margin width is as follows.
Margin on the Back Side
When duplexing, you can also specify the margin on the back side.
Auto - When [Auto] is specified, the left and right margins on the front are reversed on the back. For
example, if the left margin on the front is 1/2" (10 mm), the right margin on the back will be 1/2"
(10 mm). The top and bottom margin widths on the back will match those on the front.
Separate Front/Back Margins - Enables you to specify the front and back settings separately.
NOTE: You can set the default margin width. Refer to Default Margin on page 3-15 for details.
Follow the steps as below to use the Margin mode.
1 Place the originals in the document processor or on the platen with the top edge facing either the
rear or the left side of the copier.
2 Press [Function].
3 Press [Margin/Centering]
([Margin/Imag.Shift]).
4 Press [Margin].
5 Use [S], [T], [W] and [X] to specify the
margins.
6 When duplexing, press [Back page margin].
Margin Width
Inch models 0 to 3/4" (in 1/8" increments)
Metric models 0 to 18 mm (in 1-mm increments)
Ready to copy.
A
Paper Size
Program Function User choice Basic
Density Zoom
Cover
Booklet
Up Continuous
Scan
Mixed Size
Originals
Border
Paper
Original
Duplex
Margin/
Centering
Collate/
Offset
Original
Size
Page
Combine
Form
Overlay
Down
100%
Selection
Erase
numbering Image
Back Margin/Centering
Ready to copy.
Off
Margin
Paper Size
A
Centering
Reposition image to left /right or
top/bottom and center image o
100%
Register
Back
Select Origi
Off
Margin
Orientation.
Top Edge
Margin/Centering
Ready to copy.
Centering
Paper Size
A
Front page
Left Back page
margin
Auto
(0 18)
mm
mm
(0 18)
100%
Register
Top
0
0