TA Triumph-Adler DC 2042 - Manual (Page 28)

24
FUNCTIONS
(5) Making a margin space for binding [Margin mode]
● Left margin
The image of the original is shifted rightward to make a margin for binding on the left side
of the paper between 6 mm and 18 mm in 1 mm increments.
* If the left margin is set for the duplex copy setting, the right margin of the same width as
on the front side is set automatically on the back side.
● Top margin
The image of the original is shifted downward to make a margin for binding on the top
side of the paper between 6 mm and 18 mm in 1 mm increments.
● Front & back page margin
When duplex copies are made, margin positions and margin width can be selected
separately for the front and back sides. A binding margin space is made on each copy
between 1 mm and 18 mm in 1 mm increments.
* When the front & back page margin is set, "ON" must be selected for "
$ F&B P.
MARGIN" on page 74.
* The margin position set on the back side will be changed, depending on the position of
the margin set on the front side.
A circle ("
❍ ") indicates that the setting is possible.
1. Set the original(s).
* Set the originals so that the top (left) side of the original is at the rear side in the DF
or on the platen. Setting them in the wrong direction may cause the failure of making
margin in the correct position.
2. Touch the "FUNCTION" key.
The function selection screen will appear.
"LEFT M."
❍ ❍ ❍
Back side
Front side
"LEFT M." "RIGHT" "TOP M." "BOTTOM" "NO"
"RIGHT"
❍ ❍ ❍
"TOP M."
❍ ❍ ❍
"BOTTOM"
❍ ❍ ❍
"NO MARGIN"
❍ ❍ ❍ ❍