TA Triumph-Adler FAX 950 - Manual (Page 115)

9-9
6HFWLRQ
Other Settings and Registration
Number of Rings
The number of times the bell will “ring” in the following automatic
reception modes can be set here.
● Auto fax reception
Sets the number of “rings” (1 - 11 rings) before the fax answers an
incoming call in the Auto fax reception mode.
● TAD reception
Sets the number of times a separately purchased telephone with
answering machine capabilities will ring (1 - 15 rings) before the fax
answers an incoming call in the TAD reception mode.
* To cancel the procedure part way through, press the STOP key.
The message display will revert to the initial mode.
* If Restricted access is turned ON, it is first necessary to enter the
registered management password and then press the ENTER
FUNCTION key. Refer to “(5) Entering Your Access Code”, page 7-28.
1. Press the FUNCTION key.
2. Press the ( 씱 ) cursor key until the following message appears in
the message display.
3. Press the ENTER FUNCTION key.
4. Press the ( 씱 ) cursor key until the desired setting appears in the
message display.
> Auto fax reception
> TAD reception
5. Press the ENTER FUNCTION key.
> Auto fax reception
> TAD reception
6. Use the keypad to enter the desired number of rings for that
setting.
7. Press the ENTER FUNCTION key.
8. Press the STOP key. The message display will revert to the initial
mode.
6(7 '2&80(17
)81&7,21
6(77,1*
6(77,1*
2) 5,1*6
6(77,1*
2) 5,1*67$'
2) 5,1*6
2) 5,1*6
2) 5,1*67$'
One-Touch Dial Confirmation
ON/OFF
If One-touch dial confirmation is turned ON, it is possible to check the
message display before dialling for verification purposes.
(Refer to “”, page 2-14.)
* To cancel the procedure part way through, press the STOP key.
The message display will revert to the initial mode.
* If Restricted access is turned ON, it is first necessary to enter the
registered management password and then press the ENTER
FUNCTION key. Refer to “(5) Entering Your Access Code”, page 7-28.
1. Press the FUNCTION key.
2. Press the ( 씱 ) cursor key until the following message appears in
the message display.
3. Press the ENTER FUNCTION key.
4. Press the ( 씱 ) cursor key until the following message appears in
the message display.
5. Press the ENTER FUNCTION key.
6. Use the cursor keys ( 씱 ) ( 씰 ) to select whether you want to turn
One-touch dial confirmation ON or OFF.
7. Press the ENTER FUNCTION key.
8. Press the STOP key. The message display will revert to the initial
mode.
6(7 '2&80(17
)81&7,21
6(77,1*
6(77,1*
',$/ &21),50 02'(
',$/ &21),50 02'(
21
',$/ &21),50 02'(
2))