TA Triumph-Adler CLP 4524 - Manual (Page 93)

Operation
5-17
Date en cours : 10 janvier 2008
C:\Documents and Settings\g097447\Bureau\LU 253068043 HFC colour USB - UTAX EN\Utilisation Gb.fm
Operation
Setting yo
ur
machine
Getting started
Director
y
M
aintenance
Safety
Contents
Installation
Scanner settings
841 OK - ADVANCED FCT / COPY / B&W RESOLUTION
The B&W RESOLUTION setting to adjust the resolution for photocopying. Select the
resolution: ULTRA FAST , FAST , QUALITY or PHOTO by means of the
or , keys, validate your choice by pressing the OK key.
842 OK - ADVANCED FCT / COPY / COLOUR RESOL.
The COLOUR RESOL . setting to adjust the resolution for photocopying. Select the
resolution: DRAFT , TEXT , TEXT/PHOTO or PHOTO by means of
the or keys, validate your choice by pressing the OK key.
843 OK - ADVANCED FCT / COPY / ZOOMING
The ZOOM setting is used to reduce or enlarge part of the document by choosing the
original and the zoom value to apply to the document, 25 to 400%. Enter the zoom value
required using the keys of the digital key pad. Validate the choice with the OK key.
844 OK - ADVANCED FCT / COPY / ASSEMBLED
The ASSEMBLED parameter is used to define the choice of your printer outputs; either
assembled or not assembled. Validate the choice with the OK key.
845 OK - ADVANCED FCT / COPY / ORIGIN
If you wish, you can change the origin of the scanner.
By entering new values of X and Y given in mm (X < 210 and Y < 286), you will move
the scanning zone as shown on the figure below.
Select the X and Y coordinates with or keys.
Set the required coordinates with the numeric keypad or or . Confirm your setting
by pressing key OK.
846 OK - ADVANCED FCT / COPY / CONTRAST
The CONTRAST parameter is used to select the photocopy contrast. Adjust the contrast
using keys and , then validate the choice with the OK key.
y
D
E
BU
T F
E
U
ILLE
FIN FE
U
ILLE
x
Scanned area
TOP O
F
SHEET
TOP OF SHEET
T
O
P O
F
SH
E
E
T