TA Triumph-Adler CLP 4524 - Manual (Page 129)

Maintenance
6-17
Date en cours : 10 janvier 2008
C:\Documents and Settings\g097447\Bureau\LU 253068043 HFC colour USB - UTAX EN\MaintenanceGb.fm
Op
er
ati
on
Setting yo
ur
machine
Getting started
Director
y
Mainte
nanc
e
Safety
Contents
Installation
• restarting the transmission immediately by pressing
• abandoning transmission by pressing . To eject the document, press again.
Transmission from memory
You have the choice between:
• waiting until the transmission takes place at the given time
• restarting the transmission using the transmission queue (please see the paragraph Imme-
diately perform transmission from the waiting queue, on page 5-12). In this case, for a
document composed of several pages, the transmission will take place from the page where
the error occurred
• abandoning the transmission by deleting the corresponding command in the transmission
line (please see the paragraph Deleting a transmission on hold, on page 5-12).
The terminal makes at most 5 automatic redials. The non-transmitted document is automatically
deleted from the memory and a transmission report is then printed together with an error code and
the cause for transmission failure (see the communication error codes).
Communication error codes
The communication error codes appear in the logs and transmission reports.
General codes
Code 01 - Busy or no fax answer
This code appears after 6 unsatisfactory attempts. Call later.
Code 03 - User break
A communication has been stopped by the user pressing the
key.
Code 04 - Non programmed number
A number saved as a one-touch key or abbreviated number is not valid-check it. (Example: a
delayed transmission was programmed with a one-touch key and this key has been deleted in the
meantime).
Code 05 - Scanning default
An incident occurred with the scanner, for example, the sheet is jammed.
Code 06 - Printer default
An incident occurred in the printer: no paper, paper jam, opened cover... In the reception mode,
this incident appears only if the reception parameter is switched to
WITHOUT PAPER (please see
the paragraph Reception without paper, on page 3-6).
Code 07 - Disconnected
The link has been cut (bad line). Check the number and try again.