Rugged Cams Workhorse DVR 4 Channel - Manual (Page 82)

81
Select the area where motion is detected using the arrow (ST) and [Select] buttons.
The user can cancel the selected areas.
¸ р ¼ З ¼ ³Б ¤ Б ц ¿ ª¿ ¡ ЖД ¶ х » ц
Жч Д ¿ ½ º¸¦ А § Д ¡З С И Д
´ х º нЕ ¬ ¸¯ З С ´Щ .
» и Б ¦З Т ¸ р ¼ З ¿ µ ¿ ªА » ¼ ³Б ¤ З П°н
Е ¬ ¸ ¯ З С ´Щ .
Select the zone and press the [ESC] button.
Selecting the zone
1) To view the zone set in yellow, press the [Select] button.
2) Set the zone using the arrow buttons and press the [Select] button.
3) Once set, the zone is displayed in green.
The [Select] button may be used for toggling.
OFF
Disables the detection of motions in the video
Setting the motion detection sensitivity
On the {Recording Setup} {Data 1~4} {Event} {Motion} menu, go to the channel using
the arrow (STW X) buttons and select the [Main Setup] button. Afterward, right-click
[Motion].
To set all channels at the same time, go to {Motion} and select the [Main Setup] button.
Move the blue focus to the
motion detection-setting area,
and double-click on it.
Select the zone to detect
motion and click on it.