Rugged Cams Workhorse DVR 4 Channel - Manual (Page 81)

80
To set all channels at the same time, go to {Motion} and press the [Select] button.
On the selection box, select [Full] using the arrow (ST) and [Select] buttons.
Partial
Used to detect motion only in user-defined zones
On the {Recording Setup} {Data 1~4} {Event} {Motion} menu, go to the channel using
the arrow (STW X) buttons and press the [Select] button.
To set all channels at the same time, go to {Motion} and select the [Main Setup] button.
On the selection box, select [Partial] using the arrow (ST) and [Select] buttons.
The following figure then appears:
¸ р ¼ З ¼ ³Б ¤ Б ц ¿ ª¿ ¡ À Мµ ¿ И Д
´ х º нЕ ¬ ¸¯ З С ´Щ .
¸ р ¼ З ¼ ³Б ¤ Е © ± в ¸¦ Б ¤ З С И Д
Е ¬ ¸¯ З С ´Щ .
¸ р ¼ З ¿ µ ¿ ªА М И ® Б ¤ µ З ¸й ,
´ х º нЕ ¬ ¸¯ З С ´Щ .
Move the focus to the motion
detection-setting area.
Select zones. Double-click on the selected
zones.