Rugged Cams Vertex & Vertex RTH - Manual (Page 56)

55
① Select {Event} {Sound} for the channel using the arrow keys and the Select button.
② On the selection window, select an audio channel using the arrow keys and the Select
button.
③ Select {Event} {Sound} {Sensitivity} for the channel using the arrow keys and
the Menu button.
④ On the selection window, select audio sensitivity using the arrow keys and the Select
button.
To set all channels at the same time, go to the top of the {Sound} column and press
the [SELECT] button.
(4) Pre and Post Alarm
Used to set the recording time before and after the occurrence of an event
Post Pre
이벤트 발생 시점
5 ~ 300 Sec
① Select {Event} {Post} or {Pre} for the channel using the arrow keys and the Select
button.
② On the selection window, select the time value using the arrow keys and the Select
button.
Time is set in seconds. Whenever an event is detected, recording will be done for the set
time.
To set all channels to the same value at the same time, go to the top of the {Post} or {Pre}
column and press the [SELECT] button.
4) Alarm Out
This feature is used to generate alarms through the buzzer, mail, spot monitor, or relay in case
of an event.
(1) Buzzer
This feature is used to run the buzzer in the DVR in case of an event.
① Select {Alarm Out} {Buz.} for the channel using the arrow keys and the Select
button.
② On the selection window, select the event subject to buzzer operation (e.g., movement,
sensor, sound) using the arrow keys and the Select button and decide whether to
activate or deactivate the buzzer. Multiple time zones may be selected.
occurrence of an event
3 sec